Request an Australian-made sprocket quote with the correct chain standard, pitch, tooth count, bore and quantity—send our team the drive details.
A sprocket quote should identify the chain system, tooth count, bore arrangement, quantity and required material or machining. Australian Pulley Co manufactures and supplies industrial sprockets from Windsor, NSW. Correct identification matters more than unsupported promises that one component will eliminate every future breakdown.
What Information Identifies The Required Sprocket?
Chain pitch alone is not enough. British Standard and ASA configurations, strand count, tooth profile, bore type and shaft interface must be considered together. If the existing part is worn or modified, measurements from that sample may be unreliable and should be checked against available machinery or drive information.
Details To Include With Your Enquiry
Provide the following information so our team can identify a catalogue option or assess custom work:
- Chain Standard And Size: State the chain series, pitch and whether the drive is simplex, duplex or another arrangement.
- Tooth Count: Confirm the required number of teeth rather than estimating from outside diameter alone.
- Bore And Shaft: Provide shaft diameter, pilot-bore or taper-lock requirements, keyway and set-screw details where known.
- Sprocket Form: Identify plate, bossed, taper-lock, reverse-entry or another required configuration.
- Quantity And Timing: State whether the request is a single replacement, planned spare or recurring production quantity.
Wear Symptoms Do Not Prove The Root Cause
Hooked teeth, abnormal noise or rapid chain wear may involve lubrication, alignment, tension, contamination, loading or mismatched components. Replacing a sprocket without checking the drive can repeat the problem. Safe Work Australia’s plant risk guidance reinforces that maintenance and plant risks must be managed by competent people.
Our article on British Standard pilot-bore sprockets explains common 06B–24B chain-number relationships. It should be used as selection context, not as confirmation that a particular sprocket fits your machine.
When Custom Machining May Be Required
A standard sprocket may need its pilot bore finished for a nominated shaft, or a non-standard part may require further assessment. Material, heat treatment, tolerances and traceability should only be stated when confirmed in the quotation. We will not invent sub-0.1 mm tolerances, special tooth treatments or turnaround guarantees that have not been agreed.
What Should Be Checked Before Installation?
The supplied sprocket should be checked against the order and the drive before installation. Confirm the chain, tooth count, bore, keyway, set screws, hub orientation and available clearances. The installer should inspect the shaft, chain and adjoining components rather than fitting a new part into an unresolved fault. Isolation, guarding and recommissioning remain part of the site’s plant-safety system. Keep the product information and order record with the maintenance documentation so the next replacement does not depend on measurements taken from a severely worn component.
Request A Sprocket Quote
Australian Pulley Co supplies pulleys, chains, sprockets, couplings, bearings, belts and engineering services across Australia. Contact us with photographs, measurements, chain details and the existing part number where available. We can identify missing information and quote a suitable product or machining scope.